Explicación De Las Operaciones De Pila - Siemens SINUMERIK 802D Instrucciónes De Puesta En Marcha

5.4.2 Explicación de las operaciones de pila
Tabla 5-7 INSTRUCTIONS Set
Instruction
Load normal open
And n=1 close
Or n=0 open
Load Not normal close
And Not n=0 close
Or Not n=1 open
Output prior 0, n=0
prior 1, n=1
Set prior 0, not set
(1 Bit)
prior 1 or ½
Reset prior 0, no reset
(1 Bit)
prior 1 or ½
Instruction
prior ½ close
Edge Up
(1 PLC cycle)
prior ¿ close
Edge Down
(1 PLC cycle)
Logical Not prior 0, later 1
prior 1, later 0
No operation
Instruction
Load Byte = a = b close
a b open
And Byte =
Or Byte =
Load Byte . a ≥ b close
And Byte . a t b open
Or Byte .
Load Byte 3 a ≤ b close
a u b open
And Byte 3
Or Byte 3
SINUMERIK 802D, 802D bl Puesta en marcha (IBN), Edición 08/2005
6FC5 697-2AA00-1EP5
BASIC BOOLEAN INSTRUCTIONS
Ladder Symbol
n
n
n
Bit
S
Bit
R
OTHER BOOLEAN INSTRUCTIONS
Ladder Symbol
P
N
NOT
n
NOP
BYTE COMPARES (Unsigned)
Ladder Symbol
a
==B
b
a
> =B
b
a
< =B
b
Puesta en marcha del PLC
5.4 Programación del PLC
Valid Operands
n: V, I, Q, M, SM, T, C, L
n: V, I, Q, M, SM, T, C, L
n: V, I, Q, M, T, C, L
S_Bit: V, I, Q, M, T, C, L
n = 1
S_Bit: V, I, Q, M, T, C, L
n=1
Valid Operands
n = 0 ... 255
Valid Operands
a: VB, IB, QB, MB, SMB, AC, Constant,
LB
b: VB, IB, QB, MB, SMB, AC, Constant,
LB LB
5-89