Infiniton PAC-W12 Manual De Usuario página 32

A. MOUNTING IN SLIDING WINDOWS
 open the window halfway and mount the sealing plate from the kit vertically or horizon-
tally (18).
 move the elements of the sealing plate, adjust the distance between the plates so that they
tightly fi ll the space created after sliding the window (Fig. 5), then lock with a screw, or cut
the plate to an appropriate length without a gap
Fig. 5
 tighten the fl at end of the connector (16) of the hot air exhaust duct to the elliptical hole
(Fig. 6)
Fig. 6
CAUTION! The fl at end of the short hot air exhaust duct connector must snap into place.
B. MOUNTING IN HINGED WINDOWS
 prepare the strip with adhesive tape and Velcro from the mounting kit (19)
 open the window, attach the Velcro strip to the window frame and the
window (cut it to an appropriate length if necessary)
 close the window and attach the white fabric from the kit (19) to the strips
using Velcro fasteners
 using zip fasteners, make a gap in the white fabric large enough and put
the end of the duct (15) with the connector through it (Fig. 7)
OPERATING THE AIR CONDITIONER
1. Connect the properly assembled appliance to the mains with an earthing
pin. The connection will be signalled by a short beep. The LED displays (3h)
will show the temperature in the room.
Fig. 7