Changing The Setpoint/Max Speed - Dustcontrol DC 11-Module Instrucciones Originales

Changing the setpoint/max speed

Green System DC11-Modu-
le, description of display
Main Screen (F1)
Displays the current status of the machine.
Here you can start/stop the motor, perform a reset
after an alarm and do a fi lter clean. The F4 button
will take you to the "Service" screen from where
you can access the other screens.To access the
"Service" menu, you have to enter a "password".
This is located on the rear of the display.
Service (F4)
Here you can change the system pressure. The
factory setting is 18kPa. The start and fi lter clea-
ning functions can be tested by pressing and
holding down the "Start " or "Filter Clean" button
respectively.
F1 Return takes you back to the "Main Screen".
F2 takes you to the "After RT" screen where the
desired after-run time is set.
F3 takes you to the "Filter Clean" screen where the
desired times for fi lter cleaning are set.
2017-03-08
F4 takes you to the "Language" screen where the
language is selected.
Please see the following images of the various
screens.
After RT (F2)
Filter clean (F3)
Language (F4)
DC 11-Module - 68 Part No 94153-G