Installing On A Pipe - Samsung SCC-B5394 Guia Del Usuario

Installing on a pipe

Before installation, you have to be familiar with the above cautions and fill in the holes that are
not used for installation.
To install your camera bottom on a pipe
1. After connecting the power and video
cables, throw them inside the pipeline
and screw the male thread pipe into
the female pipe thread in your camera
tightly to fix the Main body. (In this case,
be sure to tape with Teflon tape before
assembly for waterproofing. Be careful
for the wiring cable not to be stuck in the
connection area.)
2. Adjust the angle of the camera in search
of a better view.
1) Separate the Dome cover using the
L-Wrench provided. (To make loose
the screws, rotate counterclockwise.)
2) Adjust the lens direction. For more
information, see page 17 "Adjusting
the camera direction."
3. Attach the Dome cover. (Screw the
connection bolts tightly using the
L-Wrench for waterproofing.)
To change the SAMSUNG logo position,

move the location of the connection
rubber band as show below and rotate
for assembly. (The rotation limit is 180
degree.)
13