Harbor Breeze GALILEO E-GAL52BC4GRS Manual Del Usuario página 8

FINAL INSTALLATION
2. Locate the motor housing screws pre-installed in the top of the
motor housing (E) and remove screws with a Phillips screwdriver.
Align holes in scroll iron (D) with screw holes in top of motor
housing (E). Re-install motor housing screws that were previously
removed and securely tighten screws. (Fig. 2)
Repeat procedure for remaining scroll irons (D).
3. Remove cardboard pieces from between fitter plate and blade
band.
TIP: Use of a magnetic tip screwdriver is recommended.
Locate 12 blade screws (I) and blade washers (J) in hardware
pack. Blade washers (J) for blade screws (I) can be set on each
blade screw (I) prior to installing blades (H).
Slide blade (H) through one of the narrow, rectangular openings on
blade band, aligning holes in blade (H) with holes located inside
motor housing (E). [Note: Turn blade band in order to align/insert
blade screws (I) and blade washers (J).] Insert three blade screws
(I), along with blade washers (J), and then tighten blade screws (I)
securely with a Phillips screwdriver. (Fig. 3) Repeat procedure for
each remaining blade (H).
4. Remove three screws from fitter plate on underside of motor
housing (E). (Fig. 4)
Connect female plug in the receiver to male plug from motor
housing (E). Make sure plugs connect tightly. Connect
antenna wire that extends from fitter plate to antenna wire from
receiver. Make sure molex connections on these two wires
connects tightly. (Fig. 4)
Align holes in light kit fitter (F) with holes in fitter plate.
Re-install three screws that were previously removed. Tighten
screws securely with a Phillips screwdriver. (Fig. 4)
Blade
Band
Fig. 3
E
Fitter Plate
Antenna Wire
Receiver
Fig. 4
8
Motor
Housing
Screws
D
D
E
Fig. 2
Fitter Plate
J
I
Male Plug
Female Plug
F
E
H