Automated Learning Process/Activating Code; Bulb Replacement For Up-Light; Care And Maintenance - Harbor Breeze GALILEO E-GAL52BC4GRS Manual Del Usuario

AUTOMATED LEARNING PROCESS/ACTIVATING CODE

CAUTION: The remote control transmitter (P) can be programmed
to multiple receivers or fans. If this is not desired, turn wall switch
off to any other programmable receiver or fan.
1. Locate the two batteries (O) and then remove plastic that is
wrapped around batteries (O). Remove battery cover from back
side of transmitter (P). Install the two 1.5-volt (AA) batteries (O)
provided--(refer to drawing at right).
2. Locate dimmer switch in the top left part of the battery
compartment labeled "DIM". (refer to drawing at right) Set dimmer
switch to the "ON" position. [Note: If you prefer not to have
dimming capability, set dimmer switch to "OFF" position.]
3. Restore electrical power. Within 60 seconds of restoring
electrical power, press the "LEARN" button in the battery
compartment (refer to drawing at right) for 5 seconds or until fan
switches to MEDIUM speed. Test the light and fan functions to
confirm the learning process is complete.
4. Replace battery cover on transmitter (P)--refer to drawing at
right.
IMPORTANT: To prevent damage to remote control transmitter
(P), remove the batteries (O) if not used for long periods. Store the
transmitter (P) away from excess heat or humidity.

BULB REPLACEMENT FOR UP-LIGHT

IMPORTANT: The motor housing (E), as well as the
bulbs (G) themselves, can become extremely hot when
the light has been on; therefore, please allow sufficient
time for motor housing (E) and bulbs (G) to cool down
before touching.
Replace burnt-out bulb (G) with one candelabra base
15-watt max. bulb. Repeat for each burnt-out bulb (G).

CARE AND MAINTENANCE

At least twice each year, lower canopy (B) to check downrod (A) assembly, and then tighten all screws on the fan.
Clean motor housing (E) with only a soft brush or lint-free cloth to avoid scratching the finish. Clean blades (H)
with a lint-free cloth. You may occasionally apply a light coat of furniture polish to wood blades for added
protection.
IMPORTANT: Shut off main power supply before beginning any maintenance. Do not use water or a damp cloth
to clean the ceiling fan.
E
10
P
O
DIM ON/OFF
LEARN
Battery
Cover
DIM ON/OFF
LEARN
G