Fan Mounting; Wiring - Harbor Breeze GALILEO E-GAL52BC4GRS Manual Del Usuario

FAN MOUNTING

1. Remove pin (M) and clip (N) from motor housing yoke at top of motor
housing (E) and partially loosen set screws. (Fig. 1)
*Helpful Hint: Downrod style mounting is best suited for ceilings 8 ft.
(2.44 m) high or higher. For taller ceilings you may want to use a longer
downrod (sold separately) than the one provided. Angle style mounting
is best suited for angled or vaulted ceilings. A longer downrod is
sometimes necessary to ensure proper blade clearance.
2. Insert downrod (A) through canopy (B) and canopy cover (S). [Note:
Canopy cover (S) must be turned with the shiny side toward the motor
housing (E).] Thread wires from motor housing (E) through downrod (A).
(Fig. 2)
3. Slip downrod (A) into motor housing yoke, align holes and re-install pin
(M) and clip (N). Re-tighten set screws in motor housing yoke and then
tighten nuts. (Fig. 3)
4. Install ball end of downrod (A) into mounting bracket (C)
opening. Align slot in ball with tab in mounting bracket (C). (Fig. 4)
DANGER: Failure to align slot in ball with tab may result in
serious injury or death.

WIRING

WARNING: To reduce the risk of fire, electrical shock, or
personal injury, wire connectors provided with this fan are designed
to accept only one 12 gauge house wire and two lead wires from the
fan. If your house wire is larger than 12 gauge or there is more than
one house wire to connect to the two fan lead wires, consult an
electrician for the proper size wire connectors to use.
CAUTION: Be sure outlet box is properly grounded and that a
ground (green or bare) wire is present.
WARNING: If house wires are different colors than referred to
in the following steps, stop immediately. A professional electrician
is recommended to determine wiring.
6
Set
N
Screw
M
Fig. 1
A
B
Fig. 2
A
N
M
Fig. 3
C
Ball
B
Fig. 4
E
S
E
A