Appliance Installation - Thermador PH Serie Instrucciones De Uso

Ocultar thumbs Ver también para PH Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

The hood can be mounted on a wall or suspended
from a cabinet. Both vertical and horizontal
discharge are possible with either mounting method.
Discharge Direction: The hood is shipped ready for
vertical discharge. To change to horizontal discharge
move the discharge cover shown in Figure 1a to the
top of the hood. The plate is held in place by four
screws.
Assembly of the Transition: The supplied
transition mounts to the top or rear of the hood
depending on the discharge direction.
This opening is
covered for
horizontal
discharge
Figure 1a: Discharge Direction
Dimension A
Model Number
Dimension
PH30ZS
PH36ZS
PH42ZS
PH48ZS
PH54ZS
Figure 1b: Overall Dimensions

Appliance Installation

30"
36"
42"
48"
54"
1. Align mounting holes at base of transition with
mounting holes on 1/2" flange located at the
top or rear of the hood depending on direction
of discharge.
2. Fasten transition to hood using two (2) #8
sheetmetal screws (included with hood).
3. Seal connection between transition and hood
with duct tape.
4. Remove tape holding damper closed.
See Figure 1b for overall hood dimensions.
A
27"
Page 4
This opening is
covered for vertical
discharge.
18"

Publicidad

Tabla de contenido
loading

Tabla de contenido