Kit Preparation; Kit Assembly - Metra 95-7352B Guia De Inicio Rapido

KIT PREPARATION

1. Attach the pocket assembly to the radio
housing using the (4) #8 x 1/2" Phillips
screws provided. (Figure A)
2. Attach the climate control to the radio
housing using (4) #8 x 1/2" Phillips
screws provided. (Figure B)
3. Attach the factory gauges to the radio
housing using (4) #8 x 1/2" Phillips
screws provided. (Figure B)
(Figure A)
4. Attach the provided (2) panel clips to the
upper legs and the (2) factory clips to the
lower legs of the radio housing.
Continue to Kit Assembly
(Figure B)

KIT ASSEMBLY

1. Locate the factory wiring harness in
the dash. Metra recommends using
the proper mating adapter from Metra
or AXXESS. Test the unit for proper
operation.
2. Attach the radio brackets to the
aftermarket radio using the screws
supplied with the radio, then mount the
radio into the sub-dash (Figure A)
3. Reassemble dash in reverse order of
disassembly using the radio housing
instead of the factory trim panel.
(Figure A)
REV. 2/7/2019 INST95-7352B
3