Warnings - Beta 1860E/120A Manual De Instrucciones

OPERATING AND MAINTENANCE MANUAL
CAUTION
This equipment is designed solely
for industrial or professional use.
As such, only experienced or fully
trained people should use the equipment. The user
and/or owner is responsible for ensuring inexperien-
ced personnel does not have access to the equip-
mente
A workman must look after his tools
carefully ! Remember that any tool
or equipment can become a hazard
if it is not looked after properly. Equipment in a state of
disrepair or neglect can be dangerous. If it does not
operate properly or overheats, the electricity supply
should be removed immediately and the unit should
be returned to the supplier for repair.
Read this manual carefully before using
your Welder.
You can then do a better and safer job.
By reading this manual you will
learn more about the possibilities,
limitations and potential dangers
of welding.
Retain this manual for the entire life of the equipment.
It should be kept within the operator's reach at all ti-
mes.
All equipment connected to electric power supplies
can be dangerous if the manufacturers instructions
are not read and observed.
Read, understand and observe these safety instruc-
tions to reduce the risk of death or injury from elec-
tric shock. Ensure that even bystanders are aware of,
and understand, the dangers that exist in the welding
area.
Beta Spa declines all responsibility for in-
jury or damage caused by inexperienced,
improper or neglectful use of its equipment.
The safety information contained in this
manual is a guide to ensure you are not
subjected to unnecessary risks. However,
the operator must be competent and careful at all ti-
mes.
Fires and explosions can seriously
injure or cause damage
! Read, understand and observe all
safety warnings to reduce the risk of death or injury
from fi re or explosion.
Pay particular attention to the fact that even bystan-
ders should be aware of, and understand, the dan-
gers existing in the welding area.
16
All manuals and user guides at all-guides.com
Remember that welding, by nature, produces sparks,
hot spatter, molten metal drops, hot slag and hot
metal parts that can cause fi res, can burn skin and
damage eyes..
Arc rays can damage your eyes
and burn your skin ! Read, under-
stand and observe all safety
warnings to avoid damage from arc rays. Pay particu-
lar attention to the fact that even bystanders should
be aware of, and understand, the dangers existing in
the welding area.
Wear a protective mask and make sure bystanders
do the same.
Fumes, toxic gases and vapours
can be harmful ! Read, under-
stand and observe all safety
warnings to avoid harm from toxic welding gases. Pay
particular attention to the fact that even bystanders
should be aware of, and understand, the dangers.
Carelessness while using or
maintaining the compressed gas
cylinders or regulators can injure
or kill the operator and/or bystanders ! Read, under-
stand and observe all safety warnings to avoid the
dangers of compressed gas. Pay particular attention
to the fact that even bystanders should be aware of,
and understand, the dangers.
HIGH VOLTAGE
The unit carries potentially lethal voltage.
The high voltage areas of the equipment
have been segregated and can be reached only by
using tools that are not provided with the Welder.
All maintenance or repair operations requiring access
to such areas may only be performed by Beta-trained
technicians.
FOREIGN OBJECTS
Never block the air vents with
foreign objects and avoid any
contact with liquids. Clean using just a dry cloth. These
safety precautions apply even when the unit is switched
off.
WEIGHT LOADS
The upper part of the Welder was
not designed to withstand heavy
loads. Never stand on the unit.
EN