Mode Button; Dc Voltage Measurements - koban KMDS01 Instrucciones Operativas

KMDS01
AUTORANGING MULTIMETER

MODE BUTTON

To select Diode/Continuity or DC/AC current, Temperature(C/F)
MAX HOLD BUTTON
The max. Hold position is used to measure the maximum value.
The maximum measured value is up dated continuously. Press
once again the button, will release the hold and allow a further
measurement.

DC VOLTAGE MEASUREMENTS

CAUTION: Do not measure DC voltages if a motor on the
circuit is being switched ON or OFF. Large voltage surges
may occur that can damage the meter.
1. Set the function switch to the V DC position ("mV" will
appear in the display).
2. Insert the black test lead banana plug into the negative (COM)
jack and the red test lead banana plug into the positive (V)
jack.
3. Touch the test probe tips to the circuit under test. Be sure to
observe the correct polarity (red lead to positive, black lead to
negative).
10 www.grupotemper.com