Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1800112936 FV3056U0:1800112936 FV3056U0
3-Way automatic shut-off
The iron is equipped with an electronic system that will automatically cut
the power source to your iron if it is left vertically on its heel for more than
8 minutes, on its soleplate for more than 30 seconds or on its side for more
than 30 seconds.
The auto-off warning light (
off mode.
• To restart the iron, gently shake the iron until the warning light stops
flashing.
Maintenance and cleaning
Cleaning the anti-scale valve
It is recommended that you clean the anti-scale valve once a month to
remove scale build up on the valve.
Clean the anti-scale valve as noted below:
• Unplug your iron and empty the water tank.
• Turn the
Anti-Scale valve
• Soak the valve in white vinegar or plain lemon juice for 4 hours.
• Rinse the valve under running water and put the anti-scale valve back.
21/05/08
(depending on model)
fig.11
) will flash when the iron is in the shut
• Set the steam control lever to
• Let the soleplate cool completely and empty the water tank. A small
amount of water may remain in the water tank.
• Wrap the cord around the heel of the iron and store the iron on its heel
fig.12
(
).
fig.13
(
) to remove it.
It is recommended that you clean the iron once a month to slow down
scale build up and prolong the life of the iron.
Clean your iron as noted below:
• Unplug the iron, set the steam control lever to
tank to MAX.
• Place the iron on its heel, set the temperature dial to MAX, plug in the
iron and wait for the indicator light to go out.
• Unplug the iron and place it horizontally over a sink.
• Remove the anti-scale valve (
• Gently shake the iron over the sink until all of the water (along with
impurities) runs out through the soleplate.
• At the end of the operation, put the anti-scale valve back into the iron
and allow it to heat for 2 minutes on its heel to dry the soleplate.
10:54
Page 5
When the auto-off light is
warning, it is normal for the
temperature light to remain off.
Storing your iron
and unplug the iron.
Unplug your iron and let it cool
completely before cleaning it.
The iron will not function with-
out the anti-scale valve.
Never touch the end of the
valve !
Cleaning the iron
and fill the water
fig.13
).
ENG
5
Publicidad
Tabla de contenido
