Cleaning The Limescale Filter (2) - Silvercrest SWKD 2400 A1 Manual De Instrucciones E Indicaciones De Seguridad

8.2. Cleaning the limescale filter (2)

A limescale filter (2) is installed in the pot (3). You should clean the limescale filter from time to time.
Empty the pot (3) and make sure it has cooled down.
Proceed as follows to clean the limescale filter (2):

Remove the cooled down pot (3) from the base (5).

Open the lid (13) by pressing the lid release button (1).

To remove the limescale filter (2), reach carefully
into the pot (3) with your hand as shown in the
diagram. Place your thumb from above into the
spout and press the catch (C) on the upper end of
the limescale filter (2) downwards and towards the
inside of the pot. Grip the angled tab (A) on the
limescale filter (2) with your other fingers. Pull the
lower edge (B) of the limescale filter (2) away from
the housing of the pot and remove the limescale
filter (2) from the pot (3).

After cleaning, first place the lower edge (B) of the
limescale filter (2) against the lower end of the
spout from inside the housing of the pot. Grip the
limescale filter (2) by the angled tab (A) and press
it towards the spout until the catch (C) snaps into
place.

Close the lid (13) by pressing it down until it snaps into place.
SilverCrest SWKD 2400 A1
English - 35