EMKO ESM-3722 Serie Manual De Instrucciones página 11

Minimum Humidity Set Value Parameter (Default = Minimum Value of Device Scale)
Humidity
from minimum value of device scale to maximum
Maximum Humidity Set Value Parameter (Default = Maximum Value of Device Scale)
Humidity set value can not be greater than this value.
adjusted from minimum humidity set value parameter
device scale.
Humidity Sensor Offset Parameter ( Default = 0.0 )
From -10 to 10 for Humidity Sensor (0%RH, 100%RH)
From -10.0 to 10.0 for Humidity Sensor (0.0%RH,100.0%RH)
Humidity Decrease Amount Parameter for Door Opened Control ( Default =
To detect that the door is opened, the humidity must be reduced in the amount defined by
the
Humidity Sensor (0%RH, 100%RH) From 5.0 to 20.0 for Humidity Sensor
(0.0%RH,100.0%RH)
is 5 or 5.0,
are not observed.
Humidity Decrease Amount Control Time Parameter for Door Opened Control
( Default = 20)
To detect that the door is opened, the humidity must be reduced in the amount defined
by the
Off Time of Humidity Output Parameter for Door Opened Control ( Default = 60 )
When it is detected that the door is opened, the humidity output is switched off for the time
defined by the
This parameter can be between 10 seconds and 999 seconds.
i
(1) It is valid, if the device type 0/2...10V
It is valid, if the device type 0/4...20mA
(2)
Time of Automatic Egg Tray Rotator ( Default = 00:00 )
This parameter value can be adjusted form 00:00 to 99:59 minute/second.
Repeat cycle of Automatic Egg Tray Rotator ( Default = 00:00 )
This parameter value can be adjusted form 00:00 to 24:00 hour/minute.
Alarm Output Function Selection Parameter
Note : if parameter value is 3 or 6
observed.
Note : if parameter value is 4 or 6
observed.
set value can not be lower than this value. This parameter value can be adjusted
parameter in the time defined by the
If the value decrease button is pressed while the parameter value
is displayed and this function is disabled and the parameters
parameter in the time defined by the
parameter.
Alarm is inactive.
Alarm-Temperature sensor failures.
Alarm-Humidity sensor failures.
Alarm-Temperature or Temperature sensor failures.
Alarm-Humidity or Humidity sensor failures.
Alarm-Temperature sensor failures or Humidity sensor failures.
Alarm-Temperature or Humidity or Temperature sensor failures or Humidity
sensor failures.
Humidity
parameter. From -5 to 20 for
Z Humidity Sensor Input.
Z Humidity Sensor Input
( Default = 0 )
, , , ,
, , , ,
set value parameter
This parameter value can be
to maximum value of the
parameter.
.
, or parameters are
, or parameters are
)
and
11