EMKO ESM-3722 Serie Manual De Instrucciones página 14

5.2 Alarm Output Graphics of ESM-3722
Process High Alarm
Alarm
Output
ON
OFF
Deviation Band Alarm
Alarm
Output
ON
OFF
(
Deviation Range Alarm
Alarm
Output
ON
OFF
(
5.3 Egg Tray Rotator Operation Graphics of ESM-3722
Egg Tray Rotator
Output Led
Egg Tray Rotator
Output
5.4 Failure Messages in ESM 3722 Hatcher Controller
1- Screen Blinking Temperature Sensor failure . Sensor connection is wrong or there is no sensor
connection. While this message shown on this display,if buzzer function selection
internal buzzer starts to operate.
2 - Screen Blinking H
connection. While this message shown on this display,if buzzer function selection
internal buzzer starts to operate.
3- In main operating screen if the upper display is blinking, it means that temperature alarm exits and
alarm output is active .if buzzer function selection
4- In main operating screen if the lower display is blinking, it means that humidity alarm exits and alarm
output is active .if buzzer function selection
5- Self Tune temperature error.
temperature read from the sensor is closer to the Process Set value than 5% of the scale(5 ° C for the
ProNem Mini PMI-P sensor). Self tune operation is not allowed.
Process Value
Alarm Set
- Alarm Set)
(
- Alarm Set) (
umidity Sensor failure . Sensor connection is wrong or there is no sensor
Appears on the main screen.this fault occurs when the
Process Low Alarm
Alarm
Output
ON
OFF
Alarm Set
Process Value
+Alarm Set)
i
=
Process Set Value (Temperature or Humidity)
Process Value
+Alarm Set)
is 1, 5 or 8 internal buzzer starts to operate.
is 2, 6 or 8 internal buzzer starts to operate.
Process Value
is 3, 5, 7 or 8
is 4, 6,7 or 8
14