1. Remove the protective cap from the battery
terminal.
2. Fasten the red cable and terminal cover (if
equipped) to the positive (+) terminal with the
fasteners as shown (Figure 9).
3. Fasten the black cable to the negative (-) terminal
with the fasteners as shown.
C
B
A
H
Figure 9: Battery
A - Carriage bolt
B - Wing nut
C - Black cable
D - Positive (+) terminal
E - Red cable
F - Battery
G - Battery tray
H - Terminal cover (Also see 'H' in Figure 3)
English
D
E
A
F
G
IMPORTANT! Before You Start Mowing
• Check the engine oil.
• Fill the fuel tank with gasoline.
• Check the air pressure of the tires.
• Check the level of the mower housing.
• Make sure the battery cables are attached.
• Make sure the wire is attached to the spark plug.
WARNING: Before doing any assembly or
maintenance to the mower, remove the wire
from the spark plug.
NOTE: In this instruction book, left and right describe
the location of a part with the operator on the seat.
9