Murray LT155420 Manual De Instrucciones página 36

How to Install the Wheels
If the wheels must be removed for service, make sure
they are installed as follows.
Front Wheel:
1. Make sure the valve stem is to the outside of the
tractor. Slide the front wheel on the spindle
(See Figure 43).
2. Fasten the front wheel with washer and cotter
pin. Bend the ends of the cotter pin apart to
keep the front wheel on the spindle.
3. If your model has hub caps, install the hub
caps. Make sure the washers hold the hub caps
in place.
A
B
C
Figure 43: Front wheel assembly
A - Cotter pin
B - Hub cap
C - Valve stem
D - Front wheel
E - Spindle
F - Washers
Rear Wheel:
1. Install the washers and spacer onto the axle as
shown in Figure 44.
2. Mount the square key in the key slot (See
Figure 44).
3. Make sure the valve stem is to the outside of the
tractor. Align the slot in the rear wheel with the
square key. Slide the rear wheel on the axle.
4. Fasten the rear wheel with washer and e-ring.
5. If your model has hub caps, install the hub
caps. Make sure the washers hold the hub caps
in place.
English
34 34
F
E
D
A
B
C
D
Figure 44: Rear wheel assembly
A - Rear wheel
B - Hub cap
C - E-ring
D - Washer
E - Valve stem
F - Spacer
G - Washer
H - Square key
I - Key slot
J - Axle
How to Replace the Fuse
If the fuse is blown, the engine will not start. The
location of the fuse is behind the panel between the
engine and the control console. Remove the fuse and
replace with an automotive fuse (Figure 45).
A
Figure 45: Fuse location
A - Automotive fuse
How to Replace the Light Bulb
1. Raise the tractor hood.
2. Turn the light socket until the tabs on the socket
align with the notches in the bezel (Figure 46).
Remove the light socket. Turn the light bulb
and remove the bulb.
H
I
G
J
F
E
murray.com murray.com