Murray LT155420 Manual De Instrucciones página 33

C
Figure 35: Cutting position
A - Lift lever
B - CUTTING HEIGHT positions
C - Cover
How to Replace the Motion Drive Belt
Removal:
1. Remove the mower housing. See the instructions
on "How To Remove The Mower Housing".
2. Completely push the pedal forward and engage
the parking brake.
3. Remove the idler pulley (Figure 36).
A
B
C
Figure 36: Motion drive belt removal
A - Motion drive belt
B - Idler pulley
C - Loosen the belt guides
D - Drive pulley
4. To access the belt guides, remove the battery
and battery tray. See "How To Remove The
Battery".
English
A
B
D
5. Loosen the belt guides at the drive pulley
(Figure 37).
A
Figure 37: Accessing the belt guides
A - Seat spring
B - Belt guides
6. Remove the motion drive belt from the drive
pulley (Figure 36).
7. Remove the adjuster nut from the shifter
bracket (Figure 38). Pull the motion drive belt
over the shifter bracket.
E
Figure 38: Removing the adjuster nut
A - Shift link
B - Adjuster nut
C - Shifter bracket
D - Hair pin
E - Motion drive belt
8. To remove the motion drive belt from the stack
pulley, pull the front end of the belt under the
stack pulley and then back between the stack
pulley and the steering plate (Figure 39).
9. Remove the access panel (Figure 40).
10. Remove the two screws that attach the steering
shaft assembly (Figure 40). Raise the steering
wheel and steering shaft assembly. Pull the
motion drive belt under the steering shaft
assembly.
B
A
C
B
D
31