Technical Specifications; Disposal Of Old Electrical Appliances - cecotec CONGA 2290 Manual De Instrucciones

ENGLISH
14. Right wheel error.
15. Side brush error.
16. The anti-collision sensor is blocked.
17. The free-fall sensor is not operating correctly.
Solution
1.1. The robot cannot operate with low battery. Allow it to charge before operating it.
1.2. The room temperature is below 0 ºC or above 50 ºC. Operate the robot in a room where the
temperature is between the stated temperature range.
2.1. There are too many obstacles near the charging base, relocate the charging base to an area
free of obstacles.
2.2. Clean the charging terminals.
2.3. Make sure the power switch is turned on.
2.4. The robot is too far away from the charging base, place it closer and try again.
2.5. There is very little free space around the charging base. Make sure the charging terminals
are clean.
3.1. Turn the robot off, switch it off and turn it on again.
3.2. Once the robot is turned on and has left the charging base, hold down the Back home
button on the robot until it beeps. Immediately after, let go the button and press it again until
the robot beeps again. This way the robot will be restarted.
4. The main brush, side brush or omnidirectional wheel may have foreign matters tangled, stop
the robot and clear it up.
5.1. The dust tank is full. Empty it and clear the high-efficiency filter if it is blocked.
5.2. The high-efficiency filter is blocked, clear it.
5.3. The main brush is tangled with foreign matter, please clear it up.
6.1. The Wi-Fi signal is poor. Make sure the Wi-Fi signal is correct.
6.2. The Wi-Fi connection is unstable. Reset the router, check if there are any App updates and
try again.
6.3. Make sure your device's mobile data are deactivated to improve the binding process.
7.1. Check if the robot is in Night mode and switch mode. The robot does not carry out scheduled
cleaning cycles under this mode.
7.2. Make sure the robot is connected to the network, it will not be able to carry out scheduled
cleaning tasks without being connected.
8.1. The robot will map and calculate a new route after operating under spot cleaning or after
having changed its starting position.
8.2. If the charging base is very far away from the robot, it will not be able to charge back
automatically. Put the robot back on the charging base manually.
9. Make sure the robot is not in Sleep mode, it will not resume cleaning under this mode. It
won't resume cleaning when it is placed manually on the charging base.
10. Make sure the robot is successfully connected to the network and always in the range
36
covered by the Wi-Fi signal.
11. Make sure the robot and the charging base are in an area with good Wi-Fi signal, reset the
router and try connecting them again.
12. Make sure there are no foreign objects entangled in the main brush. If there are clear them.
13. Make sure there are no foreign objects entangled or blocking the left wheel. If there are,
clean the wheel.
14. Make sure there are no foreign objects entangled or blocking the right wheel. If there are,
clean the wheel.
15. Make sure there are no foreign objects entangled in the side brushes. If there are, clean
them.
16. Press the bumper several times in the middle and on each side to unblock it.
17. Wipe the free-fall sensor and move the robot to a new location.

10. TECHNICAL SPECIFICATIONS

Product reference: 05422
Product: Conga 2290 Panoramic
100-240 V~ 50/60 Hz
Battery: 14,8 V, 3200 mAh
Frequency bands: 2.412-2.472 GHz
Maximum Transmission Power: 16 dBm
Made in China | Designed in Spain

11. DISPOSAL OF OLD ELECTRICAL APPLIANCES

The European directive 2012/19/EU on Waste Electrical and Electronic
Equipment (WEEE), specifies that old household electrical appliances
must not be disposed of with the normal unsorted municipal waste. Old
appliances must be collected separately, in order to optimize the recovery
and recycling of the materials they contain, and reduce the impact on human
health and the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation to dispose
of the appliance correctly.
Consumers must contact their local authorities or retailer for information concerning the
correct disposal of old appliances and/or their batteries.
ENGLISH
37