brennenstuhl JARO Serie Manual De Instrucciones página 14

Operating Instructions
INSTALLATION AND CONNECTION TO POWER SUPPLY 10 – 50 W
see figures p. 4, 7 and 8
1. Before installation, always switch off the voltage supply
2. Installation position: the floodlight should ideally be mounted using the wall bracket. The
floodlight must be installed at a height of less than 3 m
Recommended installation height for models with motion detector 2.5 m. The floodlight can
be angled up and down.
3. Remove the mounting bracket from the floodlight
4. Mark the position of the drill holes for fastening the mounting bracket and drill
corresponding holes into the wall
5. Open the plug connection
6. Feed the connection cable through the plug sleeve, which has a seal
7. Attach the floodlight to the mounting bracket.
8. Connect the strands of the connection cable to the luster terminal in the input connector in
accordance with
9. Slide the cases over the input connector as shown in
that both cases are sufficiently tightened – this ensures a sufficient seal.
10. Re-attach the mounting bracket to the floodlight.
11. Adjust the desired position of the floodlight and fasten the U bolts.
12. Switch the supply voltage back on
INSTALLATION AND CONNECTION TO POWER SUPPLY 80 – 150 W
see figures p. 5 and 6
Mounting position: The spotlight should be ideally fixed with the wall bracket. It must be
installed at a height less than 3 m
The light can be tilted by 90° downwards and by 45° upwards
1. Always turn off the power supply before installation
2. Unscrew the junction box
3. Insert the connection cable
braids of the connection cable according to marking N and L
4. Fasten the pressure plate and screw the junction box on
5. Remove the retaining bracket from the spotlight
6. Mark the position of boreholes
holes on the wall. Attach the bracket to the wall with suitable screws
7. Secure the spotlight to the retaining bracket
8. Adjust the desired position of the spotlight and tighten the U-bolts
9. Turn the power supply back on
14 14
20P114 LED Strahler Jaro PIR 0533228 210327.indd 14 20P114 LED Strahler Jaro PIR 0533228 210327.indd 14
. Attach the bracket to the wall using suitable screws.
2
3 .
(N = blue cable, earth symbol = green/yellow cable, L = brown cable).
5
.
7
AT .
on the back and loosen the pressure plate
2
4 through the inlet pipe of the junction box and connect the
for securing the retaining bracket and drill the respective
7
.
9
1 .
.
8
2 .
6 and tighten it. Take care to ensure
.
AT
.
1
.
4
5 .
.
6
.
8
8
JARO
.
4
.
3
7 .
.
27.03.2021 16:10:47 27.03.2021 16:10:47