1
5
10
11
10
10
SMT
3
2
3
13
Scope of supply:
3
1x back plate (1)
2x spacers, rear (2)
2
2x spacers, front (3)
2x spacers 8.5x20x13.3 (4)
4
2x spacers 8.5x20x5.4 (5)
2x washers DIN9021 A8.4 (6)
2x countersunk screws M8x75 DIN7991 (7)
6
2x countersunk screws M8x65 DIN7991 (8)
2x countersunk screws M8x55 ISO10642 (9)
7
9
8
SM/SMT preassembly
10
- Remove the screws (10).
10
SMT only:
- Remove the original back plate (11) and the original spacers.
10
SM
NOTE:
The back plate can also be mounted with the handrails on the left
63012108000* (12) and right 63012109000* (13) and with the luggage
rack system 62012020000. The handrails are available for the SMT in black
and silver.
*01S for silver
*33S for black
SM/SMT assembly
A
1
Assembly without handrails
- Insert the front spacer (3) (included with back plate) at the front.
B
- Insert the rear spacer (2) (included with back plate) at the rear.
- Position the back plate (1) (included with back plate) and mount it using
the front screws M8x65 (included with back plate, pos.A) and rear screws
M8x55 (included with back plate, pos. B) (25 Nm, Loctite 243).
A
Assembly without handrails and with the luggage rack system
- Insert the spacer 12x8.4x5mm (included with luggage rack system
62012020000) at the front.
- Insert the washer A13 (included with luggage rack system 62012020000)
at the front.
- Insert the left and right fixing plates2 (included with luggage rack system
62012020000) at the front.
NOTE:
For further assembly steps for the luggage rack system, see the manual inclu-
ded with the luggage rack system
- Insert the front spacer (3) (included with back plate) at the front.
- Insert the rear spacer (2) (included with back plate) at the rear.
- Insert the spacer 8.5x20x5.4 (5) (included with back plate) at the rear.
- Position the back plate (1) (included with back plate) and mount it using
the front screws M8x75 (included with back plate, pos. A) and rear screws
12
M8x65 (included with back plate, pos. B) (25 Nm, Loctite 243).
5