RIDGID RP 240 Manual De Isntrucciones página 8

RP 240/RP 241 Press Tools
Figure 3 – Machine Serial Number - Circled digits indicate the year and month of the manufacture.
(YY = year, MM = month).
Control
ON/OFF Button
Run Switch
Pressure
Release Button
Attachment
Mounting Pin
Figure 4 – Controls Chart
Yellow Green/Blue
Red
ON\OFF Switch
6
XX YY MM XXX
Marking Description
Main tool power switch (I = ON, O = OFF).
ON: Press button until light turns on, See Figure 5 – Tool Status Lights
OFF: Press button until light turns off
Tool will automatically turn OFF if left unused for ten (10) minutes.
Depress to start press cycle, release when tool locks on. Releasing the
switch will not stop the tool once it has locked on. This assures consistent,
—
repeatable press joint integrity.
Allows tool to be released without completing press. If used, press connection
is not complete and must be repeated
— Holds attachment to tool. Must be fully inserted for tool to operate.
Solid Light Blinking Light
Icon
Green
Blue
Yellow
Red
Green
Figure 5 – Tool Status Lights
Description
Press completed. Light on for 10 s or until
Run Switch is pressed again.
Bluetooth wireless is connected.
See Bluetooth Functions section.
Indicates service interval approaching. Starts
2,000 cycles prior to service interval (30,000
Yellow
cycles).
Tool is usable, but tool will lock after service
interval (32,000).
Tool is locked. Tool has completed service in-
terval (32,000 cycles) and requires service.
Tool has malfunctioned. Remove and rein-
sert battery. If still ON, have tool serviced.
Red Attachment mounting pin is not fully inserted.
Tool and/or battery out of Specification tem-
perature range. Bring the tool and battery to
correct operating temperature range.
Tool ON, ready to use.
Battery low. Tool will not operate. Recharge
Red
battery/Insert fully charged battery
999-995-106.10_REV. D