Cybex Platinum CLOUD Z i-SIZE Guia Del Usuario página 9

PRODUCT PARTS
Battery compartment (1)
Base (2)
Load leg (3)
Newborn inlay (4)
ISOFIX-Release buttons (5)
ISOFIX-Locking arms (6)
ISOFIX-Anchorage points (7)
ISOFIX-Indicators (8)
Load leg adjustment button (9)
Load leg indicator (10)
Carrying handle (11)
Carrying handle release buttons (12)
Seat locking indicator (13)
Linear side-impact protection
(L.S.P.) (14)
Tilt angle indicator (15)
3-point automatic belt (16)
Lap belt guide (17)
PREPARING TO INSTALL THE BASE Z
Before using the base for the first time, the plastic strip must be removed from the
Battery compartment (1) on the load leg. The Base (2) will emit an audible warning
signal until it has been correctly installed. If the Load leg (3) is folded out and
there is no sound, the battery must be checked. To check the battery, the Battery
compartment (1) on the back of the load leg can be opened with a screwdriver.
The battery may only be replaced with a CR2032 size battery.
Diagonal belt guide (18)
Green seat release button (19)
Upper seat release button (20)
Load leg parking position (21)
Headrest (22)
Headrest adjustment handle (23)
Belt adjustment button (24)
Shoulder belt (25)
Belt buckle (26)
Buckle tongue (27)
Central adjustment belt (28)
Green button (29)
Seat rotation slider (30)
Driving direction indicator (31)
Sun canopy (32)
Release handle for lie-flat position (33)
Release button for stroller adapter (34)
User guide compartment (35)
DIFFERENT USES OF THE SEAT
45 – 87 cm,
0 M – approx. 2 Y; max. 13 kg
BASE Z
BASE Z
BASE Z BASE Z
BASE Z One BASE Z One
BASE Z One BASE Z One
45 – 60 cm > 60 cm
The Newborn inlay (4) integrated at purchase should be removed if your child is
taller than 60 cm. To remove the Newborn inlay (4) open the belt buckle, pull off
the shoulder pads and then remove the inlay.
THE CORRECT POSITION IN THE VEHICLE
This is an i-Size Enhanced Child Restraint System. It is approved according
to UN Regulation No. R129/02, for use in i-Size compatible vehicle seating
positions as indicated by vehicle manufacturers in their vehicle user manuals. If
your vehicle does not have an i-Size seating position, please check the enclosed
vehicle Type List. You can obtain the most up-to-date version of the Type List from
www.cybex-online.com.
Alternatively, the car seat may be installed on forward-facing vehicle seats
equipped with a 3-point automatic belt system in accordance with UN R16.
INSTALLATION IN THE VEHICLE
Always ensure that...
• the backrests in the vehicle are locked in their upright position.
• when installing the child seat on the front passenger seat, adjust the vehicle
seat as far back as possible.
Installation of the car seat with base
1. Fold out the Load leg (3) until it locks into its foremost position. If you use
the Base Z, an acoustic warning signal will sound until the load leg has been
correctly installed.
BASE Z BASE Z
BASE Z One BASE Z One
45 – 60 cm > 60 cm
EN
7