Publicidad
Idiomas disponibles
Idiomas disponibles
3
4
5
12 A cable marked ACC1 (yellow, red (steady positive polarity)) is
located in the main wiring harness of the motorcycle on the right
side near the connector support. This cable must be connected to
the red cable in the alarm system wiring harness.
13 Connect the second cable in the main wiring harness marked ACC2
(black, red (connected positive polarity)) to the blue cable in the
alarm system wiring harness
14 Connect the turn signal cable in the main wiring harness (black,
brown) to the matching connector in the alarm system wiring
harness (yellow, black cable)
15 Mount the LED on the alarm system wiring harness.
a Drill a hole in the instrument panel with a diameter of 6.5 mm
b Pull the retaining sleeve from the LED and insert in the
instrument panel
c Insert the LED
3
from behind through the retaining sleeve
until it snaps into place.
16 Remove the left rear side section.
17 Cut out the drilling template (see annex) and position as illustrated
(see annex).
18 Punch the center and drill to a D=29mm with a cone bit.
19 Drill a hole in the storage compartment with a diameter of 10mm
(to pull the alarm system wiring harness through)
20 Remove the gasket and use a knife to cut along the right side of the
hole down to the bottom of the hole
insert the alarm system wiring harness. Mount the gasket again.
21 Remount the rear left side section.
22 Glue the alarm body
5
to the left side of the storage compartment;
make sure the loudspeaker rests on the hole (drilled with the
template).
23 Mount the tank again
24 Mount the side sections again, connect the turn signal and the tank
ventilation
25 Mount the light mask, connect the headlight
26 Screw on the bottom part of the storage compartment
27 Screw on the central part of the storage compartment
28 Mount the seat
4
. Bend the tab forwards and
5
Publicidad
