Tools Required - Whittier Wood Products 732W Hoja De Instrucciones Para Armado Inmediato

732W Cambridge Corner Entertainment Center – Parts List
ZE — #6 x 3/8" Brass
Screw — Qty. 12
ZG — #6 x 5/8" Flat Head
Screw — Qty. 48
ZI — 1¼" Black
Screw — Qty. 12
ZK — Cam Connector —
Qty. 16
TOOLS REQUIRED: Phillips Screwdriver, Slotted Screwdriver, Tape Measure, Hammer, Wood Glue.
NOTE: Due to the fact that more than one type of hardwood is used, we recommend testing for desired color.
To test for desired color on:
NOTE: In an effort to control costs and preserve natural resources, we remanufacture some components,
cutting them into smaller parts to eliminate the defects. This may result in some holes or grooves appearing
in inconspicuous locations such as the bottom of the bottom shelf. These extra holes should be disregarded
in assembling your product.
ZK
E
FIG. 1
1) Install Cam Connectors (ZK):
four in each Side Panel (A&B)
four in Center Shelf Moulding (D)
four in Base (E)
Glue Wood Dowels (ZP): three in top edge of Vertical Divider (O)
READ CAM-LOCK INSTRUCTIONS
PAGE 4 — 732W
ZF — #8 x 1" Machine
Screw — Qty. 4
ZH — 1 / " Black
5
8
Screw — Qty. 5
ZJ — 2" Black Screw — Qty. 7
ZL — Cam Housing
— Qty. 16
ASSEMBLY INSTRUCTIONS
a) Veneer parts – apply stain to unexposed portion of side panel.
b) Alder pieces – apply stain to back of base.
WOOD TRIM
B
TO FRONT
D
STAIN
TEST AREA
ZM — #6 x 1¼" Pan
Head (type 17) Black
Screw — Qty. 9
ZO — Double Magnetic
Catch — Qty. 1
IMPORTANT:
ZP
O
ZK
ZK
ZP — Wood Dowel –
. . .
ZQ — Door Skirt – Qty. 1
ZR — Locking Plug — Qty. 2
The side panels have a compression
stamp on the bottom edge:
"L" for left, "R" for right.
Vertical Divider stamped
"BOTTOM" on bottom edge
WOOD TRIM TO FRONT
A
Shoulder must be
flush with the wood!
DO NOT IMBED THE SHOULDER
(cont.)
ZN — Magnetic
Catch — Qty. 2
Qty. 3
.
ZK
INTO THE WOOD!