Honda NXR125 BROS KS Manual Del Propietário página 98

Owner's Manual
Rear Brake
Pedal Height Adjustment
To adjust the rear brake pedal (3) height, loosen the
lock nut (2) and turn the detent screw (1) until the
proper adjustment is obtained. Tighten the lock nut.
(1)
(2) (3)
Free Play Adjustment
1. Place the motorcycle on the side stand.
2. Measure the distance the rear brake pedal moves
before the brake starts to take hold.
Brake pedal free play should be: 15 – 25 mm
(0.6 – 1.0 in)
(1) Detent screw
(2) Lock nut
(3) Rear brake pedal
3. If adjustment is necessary, turn the adjusting nut (4).
(4)
(A)
(B)
4. Apply the brake several times and check for free
wheel rotation after the brake pedal is released.
NOTE
• Make sure the cutout on the adjusting nut is seated
on the brake arm pin (5) after making the final
adjustment.
• If proper adjustment cannot be obtained by this
method, see your authorized Honda dealer.
Other Checks
After adjustment, check that the stoplight turns on
when the brake pedal is applied and turns off when the
pedal is released. Make sure the brake arm, brake rod,
spring, links and fasteners are in good condition.
(4) Adjusting nut
(5) Brake arm pin
(A) Decrease free play
(B) Increase free play
(5)
19