Gallagher HR3 Instrucciones página 17

Se ng up the HR3 Hand Held EID Tag Reader
Depending on how you intend using the HR3 Reader you may need to perform one or more
of the following procedures:
• Se ng the Reader opera ng mode, see Selec ng an opera ng mode (p 18)
• Se ng the connec on to Scale, see Connec ng to the Scale (p 21).
• Via Bluetooth (wireless)
• Via cable
Note: You can also connect to a computer or other data logging device.
See "Connec ng the HR3 Reader to the computer" in the SmartReader
Confi gurator Help.
• Confi guring slave devices. Refer to "Bluetooth" in the SmartReader Confi gurator Help.
Opera ng modes
The HR3 Reader has two opera ng modes:
Memory Mode:
The captured Electronic ID tag data is stored in the Reader
in sessions un l it is transferred to computer using the MyScale
Pro so ware.
If you are in Memory mode the following screen displays:
Non-Memory Mode:
1. If you are in Non-memory mode the following screen displays:
2. The captured Electronic ID tag data is immediately sent out
the Serial port (via Bluetooth or cable) to a Scale or data
logging device and not stored in memory.
Star ng the HR3 Hand Held EID Tag Reader
17