Approvals And Standards - Gallagher HR3 Instrucciones

Approvals and Standards

This device complies with Part 15 of the FCC Rules. Opera on is subject to the
FCC
following two condi ons: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired opera on.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protec on against harmful interference in a residen al
installa on. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instruc ons, may cause
harmful interference to radio communica ons. However, there is no guarantee that
interference will not occur in a par cular installa on.
If this equipment does cause harmful interference to radio or television recep on,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separa on between the equipment and receiver.
• Connect the equipment into an outlet on a circuit diff erent from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifi ca ons not expressly approved by Gallagher Group
Limited could void the user's authority to operate the equipment.
Opera on is subject to the following two condi ons: (1) this device may not
Industry
cause interference, and (2) this device must accept any interference, including
Canada
interference that may cause undesired opera on of the device.
The carrier frequency is 134.2 kHz, the RF ouput power is 75
This category ll radiocommunica on device complies with Industry Canada
Standard RSS-310.
dBμV/m @ 10 m.
27