Gallagher HR3 Instrucciones página 24

Bluetooth Connec on
A Bluetooth connec on a empt is made when you ac vate non-memory mode. (The HR3
Reader can be confi gured to complete a Bluetooth search in either opera ng mode, i.e.
memory or non-memory, using the Confi gurator U lity.)
One of the Bluetooth search screens below will display, depending on whether slave devices
have been added in the Confi gurator U lity (on the Bluetooth tab):
Screen 1:
If no slave devices
have been added.
Is a Bluetooth connec on required?
If... then...
yes wait while a connec on is made.
The following screen displays and confi rma on of a
connec on is shown by the Bluetooth symbol on the
screen:
no a single trigger click will cancel this a empt.
The following screen displays:
Note: A single trigger click on Screen 2 (above), will
result in Screen 3 displaying. Another single trigger click
will then result in this screen displaying.
24
Screen 2:
If slave devices have been
added, the HR3 Reader
takes on 'Master' mode, and
searches for one of its slave
devices.
Screen 3:
If the HR3 Reader cannot fi nd a
slave device it automa cally
transforms to a slave and looks for
a master device, (e.g. the RS232
adaptor a ached to scales).