Wall Mount Installation - GE 29460 Manual Del Usuario

W M
ALL OUNT
Two Lines on a Single Modular Jack
1. Remove the mounting bracket. Rotate it so that the bottom of the phone
is flat. Reattach the wall mount bracket by inserting the tabs into the
slots on the top of the unit first, and then snapping the bottom tabs into
place.
2. Plug the power supply cord into the AC jack on the base and into an AC
electrical outlet.
3. Plug the gray telephone line cord into the jack marked LINE 1+2 on the
back of the base and plug the other end into a dual line modular wall
jack. For single line use, See "A Single Line on a Modular Jack. "
4. Slip the mounting holes over the wall plate posts and slide the unit
down firmly into place. (Wall plate not included.)
5. Plug one end of the handset cord into the handset and the other end
into the jack on the side of the base. Place the handset in the base.
NOTE : The phone automatically defaults to touch-tone dialing. To change to
pulse (rotary) dialing, see "Tone/Pulse Dialing." If you don't know which type of
service you have, check with the phone company.
10
I
NSTALLATION
2
1
3
5
4
SELECT
EXIT
CLEAR
DIAL
VOICE MAIL CALLER ID
PAUSE MENU DIRECTORY STORE
LOWER
REDIAL
8
1 2 3
ABC DEF CONFER
7
BUSY REDIAL
4 5 6 6
GHI JKL MNO
2 5
LINE
7 8 9
4
PQRS TUV WXYZ
VOLUME 3
0 #
* 1
TONE OPER LINE
2
FLASH HEADSET MUTE HOLD
1
SPEAKER