Wall Mount Installation - GE 26925A Guia Del Usuario

W M
ALL OUNT
Two Lines on a Single Modular Jack
1. Remove the handset hook; turn it
upside down, and put it back in the
slot. You need to do this so the
handset doesn't fall out of the base.
2. Plug the telephone line cord into the
jack marked L1 and L2 on the back of
the unit and plug the other end into a
modular wall jack.
3. Connect the power supply adapter to
the POWER 9V DC jack on the back of
the unit. Then thread it through the
bottom of base.
4. Reverse the direction of the wall
mount bracket and replace it by
putting the tabs into the slots on the
top of the unit first and snapping the
bottom tabs into place.
5. Plug the telephone line cord into the
dual line modular jack.
6. Slip the mounting holes over the wall
plate posts and slide the unit down
firmly into place. (Wall plate not
included.)
CAUTION: Use only the Thomson power supply 5-2445(white)/5-2446(black)that is
compatible with this unit. Using other adapters may damage the unit.
I
NSTALLATION
1
3
4
5
2
9