Troubleshooting - HoMedics BPW-201 Manual De Instrucciones

installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
37

TROUBLESHOOTING

If any abnormality arises during use, please check the following points:
POSSIBLE
SYMPTOMS
CAUSES
Unit does not turn Batteries have
on when the START/ run down.
STOP button is
pushed.
Battery polarities have
been positioned incor-
rectly.
EE measurement Cuff has been placed
error symbol shown incorrectly.
on display or the
Did you talk or move
blood pressure value
during measurement?
is displayed exces-
sively low
Shaking of the wrist
(or high).
with the cuff on.
E1 error symbol Air circuit
shown on display abnormality.
E2 error symbol Inflation pressure exceed-
shown on display ing 300 mmHg.
E3 error symbol Error determining
shown on display measurement data.
EP error symbol System error.
shown on display
Note: If the unit still does not work, contact HoMedics Consumer Relations.
Under no circumstance should you disassemble or attempt to repair the
unit by yourself. Contact information for HoMedics Consumer Relations
Department can be found on the warranty page (See page 41).
CORRECTION
Replace them
with two new AAA
alkaline batteries.
Re-insert the
batteries in the
correct positions.
Wrap the cuff properly
so that it is positioned
correctly.
Measure again. Keep
wrist steady during
measurement.
Measure again.
Switch the unit off,
then measure again.
Measure again.
Measure again.
38