Publicidad
Enlaces rápidos
AUTOMOTIVE PRODUCTS, INC.
MOUNT KIT
EQUIPO DE MONTAJE
JEU DE MONTAGE
27-1865
STEP BOARD
ESTRIBOS
MARCHEPIED
27-6110
27-6115
27-6510
ITEM
QTY
1,2
2
STEP BOARD, PASSENGER (1) AND DRIVER (2) (SOLD SEPARATELY)
3
2
PASSENGER BRACKET
4
2
DRIVER BRACKET
5
12
M8-1.25 X 30MM HEX HEAD BOLT
6
12
3/8" FLAT WASHER
7
12
3/8" LOCK WASHER
8
8
5/16-18 X .75" SQUARE HEAD BOLT
9
8
5/16" FLAT WASHER
10
8
5/16-18 LOCK NUT
11
8
SPACER WASHER
1,2
2
ESTRIBOS, ACOMPAÑANTE
3
2
SOPORTE DEL LADO DEL ACOMPAÑANTE
4
2
SOPORTE DEL LADO DEL CONDUCTOR
5
12
PERNOS CON CABEZA HEXAGONAL DE M8-1,25 X 30MM
6
12
ARANDELAS PLANAS DE 3/8"
7
12
ARANDELAS DE PRESIÓN DE 3/8"
8
8
PERNOS CON CABEZA CUADRAD 5/16-18 X .75"
9
8
ARANDELAS DE PRESIÓN DE 5/16
10
8
TUERCA PRESIÓN DE 5/16-18
11
8
ARANDELAS SEPARADORAS
1,2
2
MARCHE-PIEDS, PASSAGER
3
2
SUPPORT COTE PASSAGER
4
2
SUPPORT COTE
5
12
BOULON A TETE HEXAGONALE DE
6
12
RONDELLE PLATE DE 3/8 PO
7
12
RONDELLE A FREIM DE 3/8 PO
8
8
BOULON A TETE CARREE 5/16-18 X .75 PO
9
8
RONDELLES PLATES 5/16 PO
10
8
ECROU A FREIN 5/16-18
11
8
RONDELLE D'ESPACEMENT
Remove the contents from box and check for damage. Verify all parts are present. Read instructions completely before
STEP 1.
beginning.
NOTE:
Remove underbody splash guards from vehicle. Each splash guard is held in place with three bolts and four push type
STEP 2.
fasteners.
Determine passenger and driver brackets. Install brackets as shown.
STEP 3.
Insert square head bolts as shown (2 per slot, 4 per board).
STEP 4.
Attach step board to brackets as shown.
STEP 5.
tighten fasteners.
vehicle tolerances. Recommended torque values are 23 Ft. Lbs. for 8mm fasteners and 10 Ft. Lbs. for 5/16" square head
fasteners.
It is recommended to re-install splash guards. Splash guards will have to have a slit cut in the outer edge in order for the
STEP 6.
brackets to pass through.
Repeat installation for passenger side.
STEP 7.
INSTRUCTIONS-INSTRUCCIONES-CONSIGNES
APPLICATION: 2007-08 HONDA CRV
APLICACIÓN:
HONDA CRV
APPLICATION: HONDA CRV 2007-08
1 / 2
CONTENTS -
CONTENIDO
(1)
Y CONDUCTOR
"
(1)
ET
CONDUCTEUR (2)
CONDUCTEUR
M8-1,25 X 30MM
Westin does not recommend using closure strip for this application or light kit 27-6000.
SEE FIGURE 2.
Four extra spacer washers have been included to help level brackets if necessary depending on
NOTE:
, MOD. 2007-08
3
- CONTENU
(2) (SE COMPRA SEPARADO)
(ACHETE SEPAREMENT)
SEE FIGURE 1.
SEE FIGURE 3.
Make sure step board and brackets are properly aligned and
WO:
TOOLS -
HERRAMIENTA
- OUTILS
13MM SOCKET
10MM SOCKET
1/2" SOCKET
RATCHET
RATCHET EXTENSION
SMALL FLAT HEAD SCREW DRIVER
TORQUE WRENCH
UTILITY KNIFE
DADO DE 13MM
DADO DE 10MM
DADO DE 1/2"
MANERAL
EXTENSIÓN PARA MANERAL
DESTORNILLADOR DE PUNTA PLANA
PEQUEÑO
LLAVE DE TORQUE
NAVAJA
DOUILLE 13MM
DOUILLE 10MM
DOUILLE 1/2 PO
CLIQUET
EXTENSIÓN PARA CLIQUET
PETIT TOURNEVIS A BOUT PLAT
CLE DE COUPLE
COUTEAU
75-0872 REVISION 12/13/07
4
Publicidad
Manuales relacionados para Westin 27-1865
Resumen de contenidos para Westin 27-1865
- Página 1 Remove the contents from box and check for damage. Verify all parts are present. Read instructions completely before STEP 1. beginning. Westin does not recommend using closure strip for this application or light kit 27-6000. NOTE: Remove underbody splash guards from vehicle. Each splash guard is held in place with three bolts and four push type STEP 2.
- Página 2 FINISH PROTECTION Westin products have a high quality finish that must be cared for like any other exposed finish on the vehicle. Protect the finish with a non-abrasive automotive wax, (e.g. Pure Carnauba) on a regular basis. The use of any soap, polish or wax that contains an abrasive is detrimental, as the compounds scratch the finish and open it to corrosion.
- Página 3 FIGURE 3 FIGURE 2 9 10 FIGURA 3 FIGURA 2 Thank You for choosing Westin products Westin Automotive Products, Inc. For additional installation assistance please call 5200 N. Irwindale Ave. Suite 220 Irwindale, Ca. 91706 Customer service (800) 793-7846 or (507) 375-3559...