Publicidad
DOUBLE SINGLE TIER
CLOUD INSTALLATION
STEP 1
STEP 1
The Cloud blind corner
organizer can be used for
both left door/blind right
or right door/blind left
applications. Refer to Figure
1.1 to determine your cabinet
orientation. The figures in
this booklet use left door/
blind right examples. If you're
installing in a right door/blind
left application, the reverse of
the figures in this booklet will
be true for your cabinet.
If your cabinet is frameless,
proceed to Step 2. If it is a face
frame cabinet, you will need
to scab your side wall on both
tiers of your cabinet in order to
make it flush with the cabinet
opening. Measure the width
between the side wall and
cabinet opening to determine
how thick your wooden pieces
should be. The pieces need to
be at least 10" deep in order
to accommodate the support
arms (See Figure 1.2).
STEP 2
Place the support arm
template against your cabinet
sidewall furthest away from
the blind area (See Figure 2).
Follow the instructions on the
template for placement. Use
tape if necessary to affix the
template to the cabinet wall
while punching holes. Repeat
this step for the upper shelf.
STEP 3
Using an awl and rubber
mallet, punch holes to assist
in securing your fasteners.
Remove the template when
done (See Fig 3).
4
LEFT DOOR/BLIND RIGHT
MEASURE WIDTH
MINIMUM 10"
Customer Service: 800-626-1126 | rev-a-shelf.com
FIGURE 1.1
RIGHT DOOR/BLIND LEFT
FIGURE 1.2
SHELF
FIGURE 2
FIGURE 3
ATTACH
WOODEN
PIECES
Publicidad
