Publicidad
STEP 8
To hang the top shelf support
from the telescoping shaft, use
the hook that corresponds with
the desired side bracket level
(See Fig 8.1). Use the template
from step 6 to punch holes
corresponding with desired
tray height See Fig 8.2). Secure
the side bracket to the cabinet
side wall with side bracket
screws (See Fig 8.3).
#2
STEP 9
Place the support arm
template from step 2 on top
of the side bracket as shown in
figure 9. This will give you the
punch locations for the support
arm belonging to the upper
tray. Punch your holes using an
awl and rubber mallet.
STEP 10
Using the provided support
arm screws, secure the upper
and lower support arms to
the cabinet side wall (See Figs
10.1 and 10.2). At this time,
insert the plastic caps into the
support arms as shown.
#2
STEP 11
Secure the guide track to the
cabinet floor using the guide
track wood screws (See Fig 11).
#2
STEP 12
Secure the top shelf hardware
to the side bracket (See Fig
12.1). Secure to the cabinet
wall using the provided pivot
screw (See Fig 12.2).
#2
8
FIGURE 8.1
CHOOSE
DESIRED
HOOK
FIGURE 8.3
ATTACH SIDE
BRACKET
FIGURE 10.1
ATTACH
INSERT CAP
SCREWS
FIGURE 12.1
Customer Service: 800-626-1126 | rev-a-shelf.com
ATTACH
SCREWS
FIGURE 11
ATTACH
SCREWS
PIVOT
SCREW
FIGURE 8.2
PUNCH
CORRESPONDING
HOLES
FIGURE 9
PUNCH
HOLES
FIGURE 10.2
INSERT CAP
FIGURE 12.2
Publicidad
