Publicidad
2-TIER CLOUD
INSTALLATION
STEP 1
The Cloud blind corner
organizer can be used for left
door/blind right or right door/
blind left applications. Refer to
Figure 1.1 to determine your
cabinet orientation. The figures
in this booklet use left door/
blind right examples. If you're
installing in a right door/blind
left application, the reverse of
the figures in this booklet will
be true for your cabinet.
If your cabinet is frameless,
proceed to Step 2. If it is a face
frame cabinet, you will need to
scab your side wall in order to
make it flush with the cabinet
opening. Measure the width
between the side wall and
cabinet opening to determine
how thick your wooden piece
should be. The piece needs to
be at least 10" deep 20" tall in
order to accommodate both
support arms (See Figure 1.2).
STEP 2
Place the support arm
template against your cabinet
sidewall furthest away from
the blind area (See Figure 2).
Follow the instructions on the
template for placement. Use
tape if necessary to affix the
template to the cabinet wall
while punching holes.
NOTE: Keep this template
handy, as you will use it for
the upper tray in Step 9.
STEP 3
Using an awl and rubber
mallet, punch holes to assist
in securing your fasteners.
Remove the template when
done (See Fig 3).
6
BLIND RIGHT
BLIND RIGHT
BLIND RIGHT
MEASURE WIDTH
MINIMUM 10"
Customer Service: 800-626-1126 | rev-a-shelf.com
FIGURE 1.1
BLIND LEFT
BLIND LEFT
BLIND LEFT
FIGURE 1.2
NOTE: YOU WILL NEED A SUPPORT STRAP
IF THERE IS NO MOUNTING MATERIAL
OR A LOCATION FOR THE TELESCOPING
HARDWARE (SEE STEPS 6 & 7)
FIGURE 2
FIGURE 3
ATTACH
WOODEN
PIECE
Publicidad
