Publicidad
STEP 4
Place the guide track template
on your cabinet floor. Follow
the directions on the template
to orient the template
correctly. Secure template to
the floor with tape and punch
pilot holes with your awl and
rubber mallet (See Fig 4).
Repeat this step for the shelf
where the upper tray will go.
STEP 5
Using the provided support
arm screws, secure the arm
supports to the cabinet side
wall using your punched holes
as a guide (See Fig 5). At this
time, insert the plastic cap into
the support arm as shown.
#2
STEP 6
Using the provided guide track
wood screws, secure the guide
tracks to the cabinet floor and
shelf (See Fig 6).
#2
STEP 7
Slide the pivot guides onto the
guide tracks (See Fig 7).
IF YOU INTEND TO INSTALL THE SOFT-CLOSE KIT, TURN TO PAGE 10 AT THIS
STOP
TIME. OTHERWISE, PROCEED TO STEP 8 AND CONTINUE YOUR INSTALLATION.
STEP 8
Align the tray over the top of
the pivot guide and support
arm. Insert the tray into the
corresponding attachments
and press firmly into place
NOTE: Repeat steps 5-8 for
the second tray.
INSTALLATION INSTRUCTIONS: THE CLOUD: BLIND CORNER ORGANIZER
ATTACH
SCREWS
FIGURE 6
ATTACH
SCREWS
FIGURE 4
FIGURE 5
INSERT CAP
FIGURE 7
FIGURE 8
PRESS FIRMLY
INTO PLACE
SLIDE PIVOT GUIDES HERE
STOP
5
Publicidad
