Optional Accessories - Dogtra Europe E-FENCE 3500 Manual De Instrucciones

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

Connecting the Fence Wire to the Transmitter

wire is not damaged.

The Signal Field

The Field Width Adjustment Knob on the transmitter controls the signal field

width. Increasing or decreasing the signal field width does not affect the

stimulation intensity. To test the signal field, walk slowly toward the boundary

wire holding the receiver/collar at approximately the height of the dog's neck.

The contact points must be upward with the test light attached. Watch for the

test lamp to illuminate as this will give you an idea of the width of the signal

field. The most common and desirable signal strength will be found by setting

the system in the green/yellow zone, which creates a 60 - 180 cm signal area.

Yellow

Green

MIN

Field Width Adjustment Knob

Splice the two ends of the twisted wire

to each of the two ends of the fence

wire. Drill a hole through the exterior

wall or window/door sill or run the

fence wire through an existing utility

line hole. Connect the twisted fence

wire to the transmitter, either wire to

either terminal (wire ends must be

stripped 1 cm), and a red indicator light

should appear indicating a continuous

fence wire field. If no light appears,

check to make sure that all fence wires

are properly connected and that the

Orange

Red

MAX