Hamilton Beach 35200 Manual De Instrucciones página 5

How to Assemble the Deep Fryer
1. Place Base on a stable, flat surface.
2. Insert Oil Pot into Base.
3. Align grooves of Heating Element
Assembly with grooves on Base. Push
Handle, squeeze tines of Handle
Frying
w WARNING
Burn Hazard�
• Never fill oil above MAX fill mark.
• Never move fryer when it is in operation
or when fryer contains hot oil.
• Never leave fryer unattended while in use.
• Remove as much moisture from food as
Before first use: Thoroughly clean and dry
Deep Fryer. See "Cleaning your Deep Fryer"
section.
1. Place assembled Deep Fryer on stable,
level, heat-resistant surface out of reach
of children.
2. Lift Lid to open.
3. Remove Frying Basket from Deep Fryer.
4. Fill Deep Fryer with not less than 4 cups
(1 L) to no more than 8 cups (2 L) of oil
to MAX fill mark on the Removable Oil
Pot.
NOTE: Never operate unit without oil in
Oil Pot or unit will exceed temperature
limit and will require resetting.
down on Heating
Element Assembly
to connect it to
Base.
NOTE: Heater
cannot be turned
on unless correctly
installed on Base.
4. To assemble
together.
5. Align tines with
round holes on
metal bracket of
Frying Basket.
6. Release tines to allow them to spread
and then pull Handle back to lock into
metal bracket.
For storage: Push Handle into Frying
possible. Do not add water or ice to oil.
• Escaping steam may cause burns to
hands or fingers. Open lid carefully.
• Failure to follow these instructions may
result in serious burns since hot oil may
spill from fryer.
5. Attach magnetic end of Cord Assembly
NOTE: The low magnetic force allows
the cord to "break away" which
prevents unit from accidentally being
pulled off a countertop.
6. Close lid. Set Thermostat to desired
setting. Turn Timer to ON (I). Preheat
Deep Fryer until Ready-to-Cook Light
comes on (6 to 10 minutes). For more
information on temperature selection,
Basket and
squeeze tines
together to
remove Handle.
7. Align Removable
Vent Cover with
Steam Vent and
snap into place.
to fryer socket.
Magnetic end
of cord will only
go in one way.
Be careful not to
disturb magnetic
connection when
plugging cord into
electrical outlet.
5