EGO STA1500 Manual Del Proprietário página 19

WARNING:
line length will cause the motor to overheat and may result in serious personal injury.
For best results, tap the trimmer head on bare ground or hard soil. If line release is
attempted in tall grass, the motor may overheat. Always keep the trimming line fully
extended. Line release becomes more difficult as the cutting line becomes shorter.
LOAD NEW CUTTING LINE
NOTICE: Always use the recommended nylon cutting line with diameter not greater
than 0.095in. (2.4mm). Using line other than that specified may cause the string
trimmer to overheat or become damaged.
WARNING:
off and become dangerous projectiles.
WARNING:
the power head before servicing, cleaning, changing attachments or removing material
from the unit.
1. Remove the battery pack.
2. Remove the remaining cutting line,
if necessary. Simply pull it out by
hand.
3. Cut one piece of cutting line 16 ft.
(5m) long. Insert the line into the
eyelet. Push the line until the end
of the line comes out of the other
side of the trimmer head. Pull the
line from the other side until equal
amounts of line appear on both
sides (Fig. 8).
4. Press and rotate lower cover
assembly in the direction indicated
by the arrow to wind the cutting
line onto the spool that until
approximately 5.5 in. (14cm) of line
is showing on each side (Fig. 9).
Do not remove or alter the line-cutting blade assembly. Excessive
Never use metal-reinforced line, wire, or rope, etc. These can break
To prevent serious personal injury, remove the battery pack from
STRING TRIMMER ATTACHMENT — STA1500/STA1500-FC
8
Eyelet
9
Arrow Direction
5.5" (14 cm)
19