EGO STA1500 Manual Del Proprietário página 29

PROBLEM CAUSE
◾
◾
Trimmer
head will not
advance line.
◾
◾
◾
Grass wraps
around trimmer
head and mo-
tor housing.
◾
The blade is
not cutting the
line.
◾
Cracks on the
trimmer head
or the lower
cover assembly
comes loose
from the upper
cover.
The drive shaft or trimmer
head is bound with grass.
There is not enough line on
the spool.
The line is tangled in the
spool.
The line is too short.
Cutting tall grass at ground
level.
The line-cutting blade on
the edge of the guard has
become dull.
The trimmer head is worn
out.
STRING TRIMMER ATTACHMENT — STA1500/STA1500-FC
SOLUTION
◾
Stop the trimmer, remove the battery,
and clean the drive shaft and trimmer
head. Take care to thoroughly clean the
accumulated grass between the lower
cover and housing of the trimmer head
(See Fig. 23).
◾
Remove the battery and replace the
cutting line; follow the section "LOAD
NEW CUTTING LINE" in this manual.
◾
Remove the battery, remove the line from
the spool and rewind; follow the section
"LOAD NEW CUTTING LINE" in this
manual.
◾
Remove the battery and pull the lines
manually while alternately pressing down
and releasing the trimmer head.
◾
Cut tall grass from the top down,
removing no more than 8 inches in each
pass to prevent wrapping.
◾
Sharpen the line-cutting blade with a file
or replace it with a new blade.
◾
Replace the trimmer head immediately;
follow the section
"TRIMMER HEAD REPLACEMENT"
in this manual.
29