Wire Driver Wear Part; Connection Of The Torch; Gas Inlet Connection; Switch On - Oerlikon WIREFEEDER WF4 Manual Del Usuario

2.5 WIRE DRIVER WEAR PART

The wearing parts of the wire driver, whose role is to guide and
advance the welding wire, must be adapted to the type and diameter
of the welding wire used. On the other hand, their wear may affect
the welding results. Is necessary to replace them. Please refer to
paragraph 5.5 to choose wearing parts for wire driver.

2.6 CONNECTION OF THE TORCH

The MIG welding torch is connected to the European type connector,
after ensuring it has been properly outfitted with the wear parts
corresponding to the wire used for welding. For this purpose, please
refer to the torch instructions.

2.7 GAS INLET CONNECTION

The gas outlet is positioned at the rear of the power source. Simply
connect it to the pressure-regulator outlet of the gas cylinder.
● Place the gas cylinder on the trolley at the rear of the power
source and fasten the bottle using the strap.
● Open the cylinder valve slightly to allow existing impurities to
escape and then reclose it.
● Mount the pressure regulator/flowmeter.
● Open the gas cylinder.
During welding, the gas flow rate should be between 10 and 20 l/min.
WARNING
Be sure that the gas cylinder is properly secured on
the trolley by attaching the safety chain.

2.8 SWITCH ON

The main switch is located on the front panel of
the power source. Put it on position 1 to switch
power source on (and wirefeeder in case of
separated installation).
Note: This switch must never be flipped
during welding.
At each start-up, the power source displays the
software version and recognized power.
EN
9