Kohler K-6534 Guia De Instalacion página 4

Countertop
Thickness
Mounting Nut
1. Preparation
Install the water supplies and drain piping according to the
roughing-in information.
Undercounter Installations
Check to see if the faucet can be completely assembled to the
countertop and the sink.
Determine this by taking the countertop thickness plus the sink
rim thickness, 3/8" (1cm) plus or minus 1/32" (1mm), and
comparing that measurement to the available shank length
between the base of the faucet assembly and the mounting nut. If
the available shank length is the same or longer than needed,
proceed. If not, select a thinner countertop or another faucet.
Tile-In Installations
Tile backer board installed over plywood is the recommended
underlayment for installing this sink. Tile should be bonded to
the backer board with dry set or latex Portland mortar.
Acceptable underlayments include:
• Tile backer board over 3/4" (1.9cm) exterior grade plywood
• 3/4" (1.9cm) exterior grade plywood
IMPORTANT! Do not use:
• Flakeboard
• Interior grade plywood
• Gypsum wallboard
1019950-2-B
Faucet Assembly
Sink Rim
4 Kohler Co.