SOMFY pujol marathon Pro Q II Servicio Técnico página 18

Q
marathon Pro
II
Now the travel can be programmed The programming process is automatically closed at the end of a full door
cycle.
Travel Programming Process
1. Starting from the closed position, activate the time-programming mode, as described above, and the red LED
begins blinking.
2. Start the opening manoeuvre by pressing the alternative button "P.ALT" or the remote control
The opening manoeuvre is completed by activating the Opening end-of-travel stop and memorising the opening
travel length.
.
3. While the door is open, the time elapsed until the closing operation is initiated is memorized as the automatic
closing time
4. Start the closing manoeuvre by pressing the alternative button "P.ALT" or the remote control.
The closing manoeuvre is completed by activating the Close end-of-travel stop and memorising the closing
travel.
5.The programming process is automatically deactivated at the end of a full door cycle.
The maximum time that can be memorised is 2 minutes after which, the operation will end and this limit is
memorized. If programming is active, but no manoeuvre is carried out, programming mode will be disabled after 1
minute.
During programming mode the motor moves slowly.
SOFT STOP PROGRAMMING (Microswitch N° 8)
If microswitch N° 8 is in the ON position for adjustable soft stop at the end of the manoeuvre, the alternate button
must be activated during programming at the places where the soft stop to begin for both opening and closing is
desired.
For example, if programming the opening, activate the alternative button with the door closed and the door
opens.When it is almost open and it is desired to move more slowly (Soft Stop), activate the alternative button, and
the door begins to move slowly until it reaches the end of its travel. These steps program the manoeuvre and soft
stop times in the opening cycle. Repeat the steps for the closing cycle.
PEDESTRIAN OPENING (Microswitch N° 7 ON)
Using this function, the door can be opened (partially) for passage of pedestrians. It is necessary to use the multi-
channel controls programmed into the built-in receiver or use the button to open terminals 24 and 26 which
become pedestrian opening.
Programming the pedestrian travel-length: In this mode, only the pedestrian travel-length is programmed; the
soft stop and the automatic closing time will be the same as were previously programmed. If there is a remote
control with a push button memory, the following push button on the remote control activates the pedestrian
opening. (If button 1 is memorised, partial opening = button 2; if button 2 is memorised, partial opening = button
3 and so on). To set the door travel-length, start with the door fully closed. Press the programming button PATH
PROG for 1.5 seconds. The red LED indicator blinks, indicating that the device is ready for programming. Start the
opening manoeuvre by pushing the Open button or the remote control and, when the desired length of travel is
reached, press it again to stop the travel and complete the programming of the pedestrian opening.
ACCESSORIES
Radio card connector.
This allows the use of a radio card to remotely activate the automatic device; this is equivalent to pressing the
alternative button. Fit the "RADIO" bridge externally .
AUXILIARY CONNECTIONS
EXTERNAL OPERATION
The door can be operated externally by closing a contact, which is a normally open, between terminals 4 and 5
using a button or radio-controlled relay. In this case, the contact acts as an alternative button. If a switch between
24 and 26 is connected, it acts as an Open button. If a switch between 24 and 25 is connected, it acts as a Close
button, provided that the input is not configured as SEG.2 (N.C.) Safety margin on closing. configurada como SEG.2
(N.C.) / Banda de seguridad al cerrar.
English 17