SOMFY pujol marathon Pro Q II Servicio Técnico página 19

marathon Pro
FLASHING LIGHT CONTACT.
Between terminals 10 and 11 is a normally open voltage-free contact that closes when the door is in operation
and in B mode, 3 seconds before the door closes automatically.
12V OUTPUT
A 12 V DC - 0.15 A output is provided and between terminals 8 (-) and 9 (+) to power auxiliary components,
such as photocells.
COURTESY LIGHT OUTPUT
Between terminals 15 and 16 is a 230V AC outlet that is activated when the door opens and
is deactivated 3 minutes after opening.
SAFETY PHOTOCELL
The photocell, with its contact normally closed, is connected between terminals 6 and 7. It works only when
the door closes, preventing closing if the door is fully open, or reverses the manoeuvre if the door is closing.
SAFETY OPENING (23-24): SEG. 1 (NC) / 8.2 KΩ BAND (Microswitch N° 4) (test operation
possible)
With microswitch N° 4, the safety opening can be selected to act with a photocell or a strip. This safety works
only when the door opens, prevents it closing if it is fully open, or reverses the manoeuvre and closes for 1s. if it
is opening.
SAFETY CLOSING (24-25): SEG. 2 (N.C.) / BAND 8,2 KΩ (without photocell test)
be configured to act as safety input on closing using a photocell or a strip. The configuration process is carried
out at the time of programming the door travel. If during travel programming nothing is connected to input
25, it is configured as Close Button input (default). If there is an N.C. contact (Photocell) or a resistance of 8.2
the input is configured as safety closing and memorises the type of device connected
If input 25 is configured to act as safety, it loses its Close Button functionality
PHOTOCELL CONNECTION ON OPENING
(Microswitch nº 4 OFF)
RESISTIVE STRIP CONNECTION ON CLOSING
Q
II
(test operation possible)
RESISTIVE STRIP CONNECTION ON OPENING
(Microswitch nº 4 ON)
PHOTOCELL CONNECTION ON OPENING
The Close Button input can
English
Ω
18