Programming And Selecting; Delivering Hot Water; Cleaning; Cleaning The Machine - DeLonghi ECAM35075 Manual De Instrucciones

3. Turn the froth adjustment dial (D1) to "CLEAN" (fig. 21).
"Cleaning underway" appears on the display, together
with a progress bar which gradually fills as the operation
proceeds. Cleaning stops automatically;
4. Turn the dial back to one of the froth selections;
5. Remove the milk container and always clean the steam
connection nozzle (A8) with a sponge (fig. 22).
Please note!
• To prepare a number of cappuccinos or milk-based coffees,
clean the milk container after you have prepared the last
beverage only. In this case, press /ESC (B5) to go back to
the main menu.
• The milk container can be kept in the refrigerator.
• In some cases, before cleaning you must wait for the appli-
ance to heat up.
12. "

" PROGRAMMING AND SELECTING

In you can select beverages customised to your per-
sonal tastes. If the beverages have not yet been programmed,
the appliance will request the customisation procedure before
proceeding with delivery:
1. Press (B15);
2. Press the selection arrows (B2 and B4) until the required
beverage is displayed between the two lines;
Unprogrammed beverages:
3. Press OK (B3) to select;
4. Beverages with coffee: "Program aroma" appears
on the display. Press the selection arrows (B2 and B4) or
(B7) until the required aroma is selected. Press OK.
"Program coffee" appears on the display together with a
bar which gradually fills as delivery progresses. When the
required quantity is reached, press OK.
5. Cappuccinos and milk-based coffees: After select-
ing the aroma, "Program milk" appears on the display
together with a bar which gradually fills as milk delivery
progresses. When the required quantity is reached, press
OK.
6. The appliance then makes the coffee. Press OK to interrupt
delivery when the required quantity of coffee is reached.
7. "Save parameters?": to save the settings, press OK (other-
wise press ESC - B2 or B5).
8. "Parameters saved" (or "Parameters not saved"). The ap-
pliance is ready for use again.
Programmed beverages:
3. Press OK (B3) to select;
4. Preparation begins according to the previously pro-
grammed settings.
Please note:
Two cups of a beverage can only be selected when the corre-
sponding single beverages have been programmed.

13. DELIVERING HOT WATER

Important! Danger of burns.
Never leave the machine unattended while delivering hot water.
1. Make sure the hot water spout (C6) is attached correctly;
2. Place a container under the water spout (as close as possi-
ble to avoid splashes) (fig. 5);
3. Press
in the menu by pressing the selection arrows (B2 or B4)
until "Hot water" is selected;
4. Press OK (B3). A progress bar appears and gradually fills as
preparation proceeds;
5. The machine delivers about 8.45 fl oz / 250 ml of hot
water, then delivery stops automatically. To interrupt hot
water delivery manually, press the selection arrow corre-
sponding to "STOP" (B4) again.
Please note:
• If "Energy Saving" mode is active, you may have to wait a
few seconds before hot water is delivered.
• The quantity of water delivered can be customised (see
section "7.3 Program beverages").

14. CLEANING

14.1 Cleaning the machine

The following parts of the machine must be cleaned regularly:
- the appliance's internal circuit;
- coffee grounds container (A11);
- drip tray (A15) and condensate tray (A10);
- water tank (A17);
- coffee spouts (A9);
- pre-ground coffee funnel (A4);
- infuser (A20), accessible after opening the infuser door
(A19);
- milk container (D);
- hot water/steam connection nozzle (A8);
Important!
• Do not use solvents, abrasive detergents or alcohol to clean
the coffee machine.
• None of the components of the appliance can be washed
in a dishwasher with the exception of the drip tray grille
(A14) and milk container (D).
• Do not use metal objects to remove coffee deposits as they
could scratch metal or plastic surfaces.

14.2 Cleaning the machine's internal circuit

If the appliance is not used for more than 3/4 days, before using
it again, we strongly recommend switching it on and:
- performing 2-3 rinse cycles by pressing
- delivering hot water for a few seconds (section "13. Deliv-
ering hot water").
15
(B14) and scroll through the beverages
(B5);