Troubleshooting - DeLonghi ECAM35075 Manual De Instrucciones

19. TROUBLESHOOTING

Below is a list of some of the possible malfunctions.
If the problem cannot be resolved as described, contact Customer Services.
PROBLEM
The coffee is not hot.
The coffee is weak or not
creamy enough.
The coffee is delivered too
slowly or a drop at a time.
The appliance will not make
coffee
Coffee does not come out of
one or both of the spouts.
The appliance does not come
on
The infuser cannot
extracted
POSSIBLE CAUSE
The cups were not preheated.
The internal circuits of the appliance have
cooled down because 2/3 minutes have
elapsed since the last coffee was made.
A low coffee temperature is set.
The coffee is ground too coarsely.
The coffee is unsuitable.
The coffee is ground too finely.
The appliance has detected impurities in its
internal circuits. "Please wait" is displayed.
The coffee spouts (A9) are blocked.
It is not plugged into the mains socket.
The main switch (A22) is not turned on.
The power cord (C7) connector is not inserted
correctly.
be The appliance has not been turned off correctly Turn the appliance off by pressing the
REMEDY
Warm the cups by rinsing them with hot
water (Please note: you can use the hot water
function).
Before making coffee, rinse the internal circuits
by pressing the
Set a higher coffee temperature in the menu.
Turn the grinding adjustment dial (A5) one
click anticlockwise towards 1 while the coffee
grinder is in operation (fig. 7). Continue one
click at a time until coffee delivery is satisfac-
tory. The effect is only visible after delivering
2 coffees (see section "9.1 Adjusting the coffee
grinder").
Use coffee beans for espresso machines.
Turn the grinding adjustment dial (A5) one
click clockwise towards 7 while the coffee
grinder is in operation (fig. 7). Continue one
click at a time until coffee delivery is satisfac-
tory. The effect is only visible after delivering
2 coffees (see section "9.1 Adjusting the coffee
grinder").
Wait for the appliance to be ready for use again
and reselect the required beverage. Contact
Customer Services if the problem persists.
Clean the spouts with a toothpick (fig. 26B).
Plug into the mains socket (fig. 1).
Place the main switch in the I position (fig. 2).
Insert the connector as far as it will go in the
socket at the back of the appliance (fig. 1).
button (A7) (fig. 6) (see section "6. Turning the
appliance off").
23
button (B5).
→