DeLonghi ECAM35075 Manual De Instrucciones página 25

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PROBLEM
At the end of descaling, the
appliance requests a third
rinse
The milk does not come out of
the milk spout (D5)
The milk contains large
bubbles and squirts out of
the milk spout (D5) or there is
little froth
POSSIBLE CAUSE
During the two rinse cycles, the water tank has
not been filled to the MAX level.
The lid (D2) of the milk container lid is dirty
The milk is not cold enough or is not
semi-skimmed.
The froth adjustment dial (D1) is incorrectly
adjusted.
The milk container lid (D2) or froth adjustment
dial (D1) is dirty
The hot water connection nozzle (A8) is dirty
REMEDY
Follow the instructions displayed by the appli-
ance, but first empty the drip tray to avoid the
water overflowing.
Clean the milk container lid as described in the
section "14.10 Cleaning the milk container".
Use skimmed or semi-skimmed milk at refrig-
erator temperature (about 5° C). If the result is
not as you wished, try changing brand of milk.
Adjust following the instructions in section
"11.2 Adjusting the amount of froth".
Clean the milk container lid and dial as de-
scribed in section "11.4 Cleaning the milk con-
tainer after use" and "14.10 Cleaning the milk
container"
Clean the connection nozzle as described in
section . "14.11 Cleaning the hot water nozzle".
24

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido