Important Safety Information; Safety Hazards; Grounding Instructions - WAGNER Power TEX Manual Del Usario

IMportANt SAFetY INForMAtIoN

Read all safety information before operating the equipment.
Save these instructions.
To reduce the risks of fire or explosion, electrical shock and the
injury to persons, read and understand all instructions included
in this manual. Be familiar with the controls and proper usage
of the equipment.

GroUNDING INStrUCtIoNS

This product must be grounded. In the event of an electrical
short circuit, grounding reduces the risk of electric shock by
providing an escape wire for the electric current. This product
is equipped with a cord having a grounding wire with an
appropriate grounding plug. The plug must be plugged into
an outlet that is properly installed and grounded in accordance
with all local codes and ordinances.
WARNING - Improper installation of the
grounding plug can result in a risk of electric
shock.
If repair or replacement of the cord or plug is necessary, do not
connect the green grounding wire to either flat blade terminal.
The wire with insulation having a green outer surface with
or without yellow stripes is the grounding wire and must be
connected to the grounding pin.
Check with a qualified electrician or serviceman if the grounding
instructions are not completely understood, or if you are in
doubt as to whether the product is properly grounded. Do not
modify the plug provided. If the plug will not fit the outlet,
have the proper outlet installed by a qualified electrician.
This product is for use on a nominal 120 volt circuit and has a
grounding plug that looks like the plug illustrated below. Make
sure that the product is connected to an outlet having the same
configuration as the plug. No adapter should be used with this
product.
Grounded Outlet
Grounding Pin
Cover for grounded outlet box
2

SAFetY hAzArDS

WARNING - To Reduce The RIsk of
INjuRy:
•
Read all instructions and safety precautions for equipment
and spray material before operating any equipment.
•
Comply with all appropriate local, state, and national codes
governing ventilation, fire prevention, and operation.
•
This unit is intended for use with water-based textured
materials only. DO NOT use this sprayer with any flammable
or oil-based materials.
•
Keep sprayer out of the reach of children.
•
Hearing protection is recommended for extended use.
•
Always wear appropriate gloves, eye protection and a
respirator or mask when painting.
•
Do not operate or spray near children. Keep children away
from equipment at all times.
•
Do not overreach or stand on an unstable support. Certain
material overspray can make floors slippery. Keep effective
footing and balance at all times. Wear rubber-soled shoes.
•
Stay alert and watch what you are doing.
•
Do not operate the unit when fatigued or under the
influence of drugs or alcohol.
•
Use only manufacturer authorized parts. User assumes all
risks and liabilities when using parts that do not meet the
minimum specifications and safety devices of the turbine
manufacturer.
•
Wear protective eyewear and ear protection.
•
Wear long-sleeved work clothing to prevent skin irritation.
•
DO NOT pull the trigger while the turbine is turned OFF (l)
and the hopper is filled with material. Material could leak
down into the turbine.
•
Always remove turbine before cleaning.
eN