WAGNER Power TEX Manual Del Usario página 7

CleANUp
IMPoRTANT:
The Power Tex is designed to be used with
water-based materials only.
anything other than water to clean the Power
Tex.
To reduce the risk of electric shock,
always remove turbine before cleaning.
CleANUp
1.
Turn the switch OFF (O) and unplug the power cord.
Make sure the hopper is empty of spraying material. Pour
any leftover material into a separate container. Remove the
hopper when empty.
2.
Unlock turbine from sprayer by turning the two halves in
opposite directions.
The "unlock" symbol on the turbine should come toward the
guide on the sprayer. Set turbine aside in a dry area.
3.
Remove nozzle from the sprayer.
4.
The nozzle, sprayer and the hopper can now be hand-cleaned
using warm, soapy water and the cleaning brush provided
with the unit.
Let faucet water run into the area where the hopper connects
to the sprayer. While the water is running, activate the
trigger to fully clean the nozzle area . do NoT sumberge the
turbine. The outside of the turbine can be wiped clean with
a damp cloth.
5.
With the lubricant included with your sprayer, lubricate the
O-ring on the hopper (a) and lubricate the outer edge of the
plunger inside the rear of the sprayer housing (B).
Pull and release the trigger a few times to distribute the
lubricant.
6.
After all components are clean, wipe down with a dry cloth.
Reassemble the sprayer/turbine. ON/OFF switch should be
facing upward. Clean turbine labels with a damp cloth.
1
Do not use
2
3
4
5
6
eN
IMPoRTANT:
do NoT attempt to
remove the hopper
from the sprayer if it
is full of material.
some water may
flow out the rear of
the sprayer body.
(B)
(A)
7